Welcome to our site Cheap Acoustic Guitars. Don"t forget to bookmark this page Switch Plate. If you found what your looking for, please remember to click an appreciation button above for this page.
![]() Quality Telecaster electric guitar control switch plate in chrome black or gold US $6.31
|
Switch Plate

Drywall DIY
If you have a hole in your wall, you can fix it yourself and it is a lot easier than you would have thought. There's no need for anyone else to do it even if the hole is quite large. The following tips can help to make this repair.
YOu're ready to fix that hole in the wall so now it is time to gather what you will need for the job. These are: sandpaper in both fine and coarse grit, compound and putty knives. If you are working with a bigger hole, you will need drywall, drywall nails and screws and a trowel. Before you begin, clean the area surrounding the hole to ensure that the compound will adhere to the wall.
A hole made by a screw or nail can be easily fixed up with a putty knife and putty. Just smooth the putty over the area until covered evenly. For larger holes where a light switch or outlet had previously been, insert newspaper into the hole as a filler before applying putty. Always remember to use putty knife that is wider than the hole to ensure that the area is fully and smoothly covered over. After it dries, sandpaper will ensure the finish is as smooth as it can be.
When you have a medium size hole which can be defined as no larger than 10 inches, a hot patch is required. This is done by cutting a piece of drywall about the size and shape of the hole, then applying drywall tape to the edges folded up like a tab so it can adhere to the wall. Then apply drywall compound to the whole area and repeat three or four times until it is smooth and even.
When you have a medium size hole, you are pretty well rebuilding a full piece of wall. Start off by taking away the damaged drywall. Remove it from one stud to the other. Now cut another piece of drywall approximately the same size as the new opening. Attach this to the studs with drywall nails or screws. Try to keep the seams as little as possible to avoid trying to fill in gaps later. Apply drywall tape to the seams and then apply putty with a putty knife or trowel. Let the area dry for atleast 24 hours before sanding down the bumps and rough spots on the surface. Repeat this procedure once or twice more to ensure that the new part of the wall is flush with the old part of the wall.
Over spackling can make your work look unprofessional which you don't want to happen. You want people to think an expert did it and then compliment you when they find out it is your excellent workmanship. The way to do this is to apply compound three or four times in small amounts instead of one or two coats of a lot of compound. Always be sure to let the area dry between applications. Now you've got a professional looking finish that will get noticed. If you still feel doing your own drywall repair is too much, then hiring a drywall contractor is not the end of the world.
If you are looking for a different item here are a list of related products on Cheap Acoustic Guitars, please check out the following:





















































































